Welcome to the N1IR Electronics Website. Totally off the cuff, one take, unrehearsed video projects for anyone interested in amateur radio, electronic design, makers, hardware hackers and science.

Get off your duff and build something!
Training the hand and mind since 1982.


TV-B-Gone Bare Board

Insert Blue IR LED Flat side toward 1K Resistor
Bend LED 90 Deg as shown

Install PB Switch

Install Resonator there is NO polarity

Install 1K Ohms Resistor

Install 30 ohm resistor
Install 8 pin IC socket

Install Yellow LED Flat Side toward Edge of board

Install Cap Positive faces Blue IR LED

Install 2 AA Battery Holder

Place programmed IC into socket pin 1 facing PB switch

To order kit Click on Link Below